Concrete cutting in Mission Viejo CA - clean lines right where you need them
Need a trench for a new pipe or a section of slab taken out? We cut clean, straight lines after checking what's inside.
Can you cut through my slab without wrecking the rest of it?
Concrete cutting in Mission Viejo, CA, means sawing straight lines through an existing slab or wall, or core drilling round holes for pipes, drains and conduit, so you end up with a clean edge instead of a jagged, broken one.
Usually the call comes because something has to go through or under the concrete, like a new drain line across a garage floor, or because one sunken section needs to come out without cracking everything around it. The price moves with how thick and how heavily reinforced the concrete is, whether we're sawing a slab or a wall, how many feet and holes you need and whether we're hauling the pieces away, and on a small job the cost of bringing the crew and saws out can be most of it. The schedule mostly turns on whether the slab needs a scan before the first cut and whether there's a permit and inspection involved, so when I come out I'll walk you through both and give you a number for your own job.
How our concrete cutting jobs go, start to finish
I start by looking at the slab with you and asking what the cut is for, because a trench for a pipe and a section coming out for good get planned differently. Before we cut into any existing slab, I ask whether it could be post-tensioned, built with steel cables pulled tight inside it, and when there's any doubt we get it scanned before the saw touches it. Then we mark the lines, make straight cuts with a walk-behind saw or a hand saw for the tight corners, core the round holes for pipes and drains, and break out the pieces when that's part of the job. California stormwater guidance says the wet gray paste the saw leaves behind, called slurry, should be kept out of storm drains, so we don't let it run down the gutter and we clean it up before we go.
A lot of cutting is the first half of a bigger job. When we cut out a sunken or broken section, or cut a clean edge so new concrete can tie in, we can pour the replacement too, whether that's a stretch of new concrete driveway or a wider concrete patio. On those pours I'd rather spend your money on the base than on a fancy finish, digging out and packing the dirt the slab sits on, because a nice surface over loose dirt sinks right along with it.
Why Mission Viejo homeowners call Prestige Mission Viejo Concrete Company for cutting
The owner is on every job
I come out to look at every job myself, and our crew does the cutting with me there on site. So the person who asked about cables and marked your lines is the one standing next to the saw.
Licensed and insured, easy to check
We're licensed and insured. The state licensing board lists concrete sawing, breaking and coring under its concrete-related services license, so you can look up any cutter you're comparing.
Based in Mission Viejo since 2017
I started this business here in Mission Viejo in 2017. We work across south Orange County and the cities around it, including Lake Forest and Laguna Hills, so you're not paying for a crew driving in from far off.
We know who oversees street work
If a cut runs into the public strip along the street, like the end of a driveway, that work falls under Mission Viejo's Public Works Department. We figure out who's involved before we mark a line, so you know where things stand before the saw starts.
On a cutting job, the planning before the first cut matters more than the cut itself. Send us your job or call (949) 619-8245, and have handy the surface you want cut, the rough length in feet, any holes you need, and whether you know the slab is post-tensioned.
Get a free on-site estimate for your concrete cutting
Send the form and we'll get back to you within one business day to set up a visit. I'll look at the slab, measure the cuts and holes with you, and leave you with a free quote. There's no obligation to book.
Cuts, cores and clean edges
What people ask before concrete cutting
How much does concrete cutting cost in Mission Viejo?
Professional saw cutting of concrete slabs across the US usually costs about $4 to $15 per linear foot, and that covers the sawing, not hauling the pieces off. It's a national figure, so treat it as a ballpark. For a Mission Viejo number on your own slab, call (949) 619-8245 and I'll come measure it.
Does the concrete cutter haul away the cut pieces?
Not always, because sawing concrete and removing it are separate jobs, and some cutters make the cuts and leave the panels sitting where they were. Ask whether a quote covers removal or only the sawing. Ours says plainly whether we're hauling the cut pieces away or leaving them in place, so there's no surprise pile in your yard.
How do permits and inspections work for concrete work in Mission Viejo?
Mission Viejo takes all permit applications and inspection requests online, through the city's building services system. An inspection happens the next business day when the request goes in before 4 PM the day before, so it gets booked a day ahead. When a job needs a permit, we take care of the application and book the inspections with the city, and we keep you posted along the way.
Is it safe to cut a post-tensioned slab?
Only after the cables are found, because cutting one releases all its stored tension at once. A cut cable can whip, blow out its anchor, collapse the slab and kill someone, so the scan comes before the saw and the time for it goes into the schedule.
How do I find out what's inside my slab before it's cut?
A scan of the concrete looks for rebar, the steel bars inside, along with conduit, pipes, post-tension cables and anything else you don't want a blade to hit. Scans have limits, since crowded steel, a weak signal or a hard-to-reach spot can leave real unknowns, and a scan that finds nothing doesn't prove nothing is there. If the picture isn't clear, we talk it through with you before we cut.
What is the best way to keep dust down when cutting concrete?
Cutting wet is the usual answer, because water stops the fine silica dust right where the blade makes it. One field guide says to cut wet and allows dry cutting only with a vacuum dust extractor running. Either way, it's smart to keep kids, pets and open windows away from the work.
Work that often follows a cut
- Concrete driveway building
If cutting out a sunken stretch shows the rest of your driveway is tired too, a new driveway on a properly packed base may make more sense.
- Concrete patio construction
Once a section is cut out for a new drain or a wider footprint, we can pour a patio that ties in cleanly and drains away from the house.